Weider 1200 English Manual - Page 7

ASSEMBLY Make Assembly Easier Everything in this manual is designed to ensure that the weight bench can be assembled successfully by almost anyone. Set aside plenty of time, so that assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. • Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Assembly requires the included hex key(s) and the following tools (not included): two adjustable wrenches one rubber mallet one standard screwdriver one Phillips screwdriver Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. Frame Assembly 1 1. Before beginning assembly, make sure that you have read and understand the information in the box above. Attach a Stabilizer Foot (51) to the Stabilizer (5) with two M4 x 20mm Screws (56) and two M4 Washers (82). Attach another Stabilizer Foot in the same way. Insert two M10 x 67mm Carriage Bolts (14) up through the Stabilizer (5). Insert two M8 x 65mm Carriage Bolts (1) up through the Base (4). Note: It may be helpful to place a piece of tape over the bolt heads to hold the Carriage Bolts in place. Orient the Stabilizer (5) so that the small holes are on the indicated side. Attach the Base (4) to the Stabilizer with the two M10 x 67mm Carriage Bolts (14) and two M10 Nylon Locknuts (21). Do not tighten the Nylon Locknuts yet. 21 4 1 51 Small Holes 14 5 51 82 56 7