Weider 235 Uk Manual - Page 6

ASSEMBLY Make Assembly Easier This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. • For help identifying small parts, see the PART IDENTIFICATION CHART on page 5. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included hex key and grease packets, the following tools (not included) may be required for assembly: • Two adjustable spanners • One rubber mallet • One standard screwdriver • One Phillips screwdriver Assembly will be more convenient if you have a socket set, a set of open-end or closed-end spanners, or a set of ratchet spanners. 1. Before assembling the weight bench, make sure that you have read and understand the information in the box above. Attach the Crossbar (3) to the two Uprights (1) with four M8 x 53mm Bolts (14), four M8 Washers (12), and four M8 Nylon Locknuts (13). Do not tighten the Nylon Locknuts yet. 1 12 14 1 13 3 13 13 1 12 14 2. Orient the Stabilizer (31) so the recessed holes 2 are facing the floor. Attach the Stabilizer to the Front Leg (8) with two M8 x 43mm Carriage Bolts (29) and two M8 Nylon Locknuts (13). Do not tighten the Nylon Locknuts yet. 13 Recessed Holes 29 8 13 31 6