Weider 235 Uk Manual - Page 8

7. Attach the two Backrest Tubes (5) to the Backrest (6) with four M6 x 38mm Screws (22) and four M6 7 Washers (20). Do not tighten the Screws yet. 6 5 20 20 22 22 8. Insert the Support Rod (7) through a set of holes 8 in the Uprights (1). Make sure that the locking pin is on the side shown. Rotate the Support Rod to the locked position, with the locking pin wrapped around the right Upright. 1 Apply grease to an M10 x 137mm Bolt (28). Attach the Backrest Tubes (5) to the welded tube on the Frame (2) with the Bolt, two M10 Washers 7 1 (26), and an M10 Nylon Locknut (25). Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily. See steps 1-3. Tighten the M8 Nylon Locknuts Locking Pin 25 26 5 (13) used in these steps. See step 7. Tighten the four M6 x 38mm Screws (22). 2 Welded 26 28 Tube 9. Attach the Seat (11) to the brackets on the Frame (2) with four M6 x 16mm Screws (21). 9 11 2 21 8