Weider 30ct English Manual - Page 5
Assembly
View all Weider 30ct manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Make Things Easier for Yourself Everything in this manual is designed to ensure that the weight system can be assembled successfully by anyone. However, it is important to realize that the versatile weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two people. • As you assemble the weight system, make sure all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • Assembly is divided into five stages: 1) frame assembly, 2) arm assembly, 3) cable assembly, 4) seat assembly, and 5) VKR assembly. The hardware for each stage is packaged separately. Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage. • For help identifying small parts, use the PART IDENTIFICATION CHART in the center of this manual. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been preattached. The following tools (not included) are required for assembly: • Two adjustable wrenches • One rubber mallet • One standard screwdriver • One Phillips screwdriver • Lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. FRAME ASSEMBLY 1 1. Before beginning assembly, be sure that you have read and understand the information in the box above. Locate and open the parts bag labeled "FRAME ASSEMBLY." Press two 2" Square Outer Caps (51) onto the Stabilizer (5) in the indicated locations. Press a 2" Square Inner Cap (27) into the end of the Base (4). Insert six 5/16" x 2 1/2" Carriage Bolts (1) up through the Stabilizer (5). Insert two 5/16" x 2 1/2" Carriage Bolts up through the Base (4). Attach the Base (4) to the Stabilizer (5) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Washers (8), and two 5/16" Nylon Locknuts (3). Do not tighten the Nylon Locknuts yet. 5 51 11 8 5 1 1 3 1 4 51 1 27