Weider Club C4800 English Manual - Page 15

25. Identify the Upper Short Stack Cable (63). 25 Attach the Cable inside the Top Frame (9) with an M10 x 65mm Bolt (80), two M10 Washers (99), 99 9 and an M10 Nylon Locknut (101). 101 99 63 80 26. Wrap the Upper Short Stack Cable (63) under a 100mm Pulley (38). Attach the Pulley and a Long Cable Trap (68) to the indicated hole in a "U"bracket (40) with an M10 x 50mm Bolt (81) and an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 27. Route the Upper Short Stack Cable (63) up through the Top Frame (9) and over a 100mm Pulley (38). Attach the Pulley inside the Top Frame with an M10 x 65mm Bolt (80), two M10 Washers (99), two 12.5mm Spacers (69), and an M10 Nylon Locknut (101). 28. Route the Upper Short Stack Cable (63) over a 100mm Pulley (38) and down through the Top Frame (9). Attach the Pulley inside the Top Frame with an M10 x 65mm Bolt (80), two M10 Washers (99), two 12.5mm Spacers (69), and an M10 Nylon Locknut (101). 26 63 68 38 81 101 40 27 63 9 38 101 99 69 69 99 80 28 38 101 99 69 9 63 69 99 80 29. Set the tether on the other Weight Pin (98) over 29 the Short Weight Tube (24). Set a 50mm Washer (95) on the Weight Tube. Thread an M12 Nut (58) all the way onto the Upper Short Stack Cable (63). Screw the Cable partway into the Short Weight Tube (24). Tighten the Nut against the 50mm Washer (95). 63 98 58 95 24 15