Weider Club C4800 English Manual - Page 19
Trap 68 to the Leg Press Base 3 with an M10
View all Weider Club C4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
44. Note: The following steps are shown from the 44 back of the weight system. Route the Leg Press Cable (65) under a 100mm Pulley (38). Attach the Pulley and a Long Cable Trap (68) to the Leg Press Base (3) with an M10 x 92mm Bolt (55), an M10 Washer (99), and an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 45. Wap the Leg Press Cable (65) around a 90mm 45 Pulley (39). Attach the Pulley and a Short Cable Trap (48) to the M10 x 121mm Carriage Bolt (49) in the Base (1) with an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 46. Wap the Leg Press Cable (65) under a 90mm 46 Pulley (39). Attach the Pulley and a Short Cable Trap (48) to the Base (1) with an M10 x 50mm Bolt (81) and an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 3 101 99 38 65 55 68 101 48 39 65 1 49 101 65 47. Attach the end of the Leg Press Cable (65) to the "U"-bracket (40) with an M8 Washer (100) and an M8 Nylon Locknut (87). Note: Do not completely tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset drawing. 48. Identify the Ab Cable (66). Route the Cable under a 100mm Pulley (38) and through the Leg Lever (7) and the Leg Lever Base (5). Attach the Pulley inside the Leg Lever with an M10 x 65mm Bolt (80), two M10 Washers (99), two 12.5mm Spacers (69), and an M10 Nylon Locknut (101). Make sure the large ball on the Cable is in the position shown. 81 1 39 48 47 87 100 87 40 65 65 48 5 99 80 69 7 99 69 101 38 66 Large Ball 19