Weider Easy Compact 90 Uk Manual - Page 13
Maintenance
View all Weider Easy Compact 90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
MAINTENANCE Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the weight pin (not shown) into the center of the weight stack (not shown). Next, locate the Large Pulley Plates (95). Remove the M10 Nylon Locknut (57) and the M10 x 50mm Bolt (64) from the Large Pulley Plates, the upper 90mm Pulley (27), and the Cable Trap (51). Reattach the Pulley and the Cable Trap to the Large Pulley Plates using a hole closer to the center of the Large Pulley Plates. Make sure that the Cable Trap is in the proper position and that the High Cable (30) is between the Cable Trap and the Pulley. To further tighten the cables, change the position of the lower 90mm Pulley (27) in the same way. Another way to tighten the cables is to change the position of the 90mm Pulley (27) attached to the "U"-bracket (18). Remove the M10 Nylon Locknut (57) and the M10 x 50mm Bolt (64) from the "U"bracket, the Pulley, and the Cable Trap (51). Reattach the Pulley and the Cable Trap to the "U"bracket using the higher hole in the "U"-bracket. Make sure that the Cable Trap is in the proper position and that the Low Cable (31) is between the Cable Trap and the Pulley. 51 57 27 30 27 95 64 57 51 18 64 27 31 Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and reinstall it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual. 13