Weider Pro 9648 English Manual - Page 18

CABLE ASSEMBLY 36. Attach the Press Bracket (94) to the Leg 36 Press Arm (96) with a 5/16Ó x 3Ó Bolt (75) and a 5/16Ó Nylon Locknut (3). Wrap the Leg Press Cable (99) around a 3 1/2Ó Pulley (15). Attach the Pulley to the Press Bracket (94) with the 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut (21). Slide a 5/16Ó Flat Washer (8) onto a 5/16Ó x 2 3/4Ó Bolt (11). Insert the Bolt through the lowest hole in the Rear Seat Frame (100) from the indicated side. (Note: The three holes are for cable adjustment.) Tighten a 5/16Ó Nylon Jam Nut (93) onto the Bolt. Slide the end of the Leg Press Cable (99) onto the end of the Bolt. Thread another 5/16Ó Nylon Jam Nut onto the Bolt. Do not fully tighten the second Jam Nut. There must be room between the two Jam Nuts for the end of the Cable to pivot. 96 12 11 3 8 99 94 75 15 21 100 93 SEAT ASSEMBLY 37. Locate and open the parts bag labeled ÒSEAT ASSEMBLY.Ó Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (92) through the center hole in a Seat Plate (37). Attach the Seat Plate to the Rear Backrest (85) with two 1/4Ó x 1/2Ó Screws (18). Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (92) through the indicated hole in the Leg Press Upright (56). Tighten a 1/4Ó Nylon Locknut (2) with a 1/4Ó Flat Washer (10) onto the Carriage Bolt. Attach the top of the Rear Backrest (85) to the Leg Press Upright with a 1/4Ó x 2 1/2Ó Screw (43) and a 1/4Ó Flat Washer (10). 38. Attach one end of a Seat (13) to the Rear Seat Frame (100) with two 1/4Ó x 1/2Ó Screws (18). Attach the other end of the Seat to the Rear Seat Frame with a 1/4Ó Flat Washer (10) and a 1/4Ó x 2 1/2Ó Screw (43). 37 85 56 10 43 37 18 92 2 38 13 18 10 43 100 18