Weider Pro 9648 English Manual - Page 5

5

ASSEMBLY

1

8

11

51

27

1

4

3

1

51

5

1.

Before beginning assembly, be sure that

you have read and understand the infor-

mation in the box above.

Locate and open the parts bag labeled

±FRAME ASSEMBLY.²

Press two 2° Square Outer Caps (51) onto

the indicated locations on the Stabilizer (5).

Press a 2° Square Inner Cap (27) into the

end of the Base (4).

Insert six 5/16° x 2 1/2° Carriage Bolts (1) up

through the Stabilizer (5). Insert two 5/16° x

2 1/2° Carriage Bolts up through the Base

(4).

Attach the Base (4) to the Stabilizer (5) with

two 5/16° x 2 3/4° Bolts (11), two 5/16° Flat

Washers (8), and two 5/16° Nylon Locknuts

(3).

Do not tighten the Nylon Locknuts

yet.

FRAME ASSEMBLY

Before beginning assembly, carefully read the

following information and instructions:

¥

Place all parts of the PRO 9648 in a cleared area

and remove the packing materials; do not dis-

pose of the packing materials until assembly is

completed.

¥

The assembly is broken into five stages: 1) frame

assembly, 2) press and butterfly arm assembly,

3) cable and pulley assembly, 4) seat and back-

rest assembly, and 5) VKR assembly. The hard-

ware for each stage is packaged separately.

¥

Wait until you begin each assembly stage to open

the parts bag labeled for that assembly stage.

¥

For help identifying the small parts used in

assembly,

use the PART IDENTIFICATION

CHART located in the center of this manual.

Note: Some small parts may have been pre-

attached for shipping. If a part is not in the parts

bag, check to see if it has been pre-attached.

¥

As you assemble the PRO 9648 be sure that all

parts are oriented as shown in the drawings.

¥

Tighten all parts as you assemble them, unless

instructed to do otherwise.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE

REQUIRED FOR ASSEMBLY:

¥

Two (2) adjustable wrenches

¥

One (1) standard screwdriver

¥

One (1) phillips screwdriver

¥

One (1) rubber mallet

¥

Lubricant, such as grease or petroleum jelly,

and soapy water will also be needed.

Assembly will be more convenient if you have the

following tools: A socket set, a set of open-end or

closed-end wrenches, or a set of ratchet wrenches.

1

Weider Pro 9648 English Manual - Page 5

Assembly

Page 5 highlights