Weider X2 Uk Manual - Page 15
Nance And Trouble-shooting
View all Weider X2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
29. Insert an M6 x 38mm Carriage Bolt (74) into the centre hole in each Seat Plate (23). Attach each Seat Plate to the Seat (19) with two M6 x 15mm Screws (78). Turn the Seat (19) so the wide end is in the position shown. Insert the two M6 x 38mm Carriage Bolts (74) into the indicated holes in the Seat Frame (7). Secure the Carriage Bolts with two M6 Flat Washers (80) and two M6 Nylon Locknuts (79). 29 19 74 23 7 78 23 74 78 80 79 30. Press a 19mm Round Inner Cap (42) into each end of 30 the Long Pad Tube (83) and the Short Pad Tube (84). 42 Slide the Long Pad Tube (83) into the holes in the 32 bracket on the Seat Frame (7). Slide a Large Foam Pad (32) onto each end of the Long Pad Tube. 83 Slide the Short Pad Tube (84) into the hole in the Leg 7 Lever (8). Slide a Narrow Foam Pad (33) onto each end of the Short Pad Tube. 42 33 84 8 32 42 33 42 31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 17 of this manual. Before using the training system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE AND TROUBLE-SHOOTING on page 19. 15