Weslo Aerobike 1500 Owners Manual - Page 10

DUAL-ACTION MODE To convert the handlebars to the dual-action mode, first remove the link arms from the lock rod on the frame. Press the link arms outward against the pedal washers, while pulling against the bottom of the pedal washers with your fingers. Slide the link arms onto the pedal bushings. It may be helpful to move the link arms up and down slightly until they slide onto the bushings. To isolate the muscles of the upper body, you can rest your feet on the side shields and exercise using only your arms. pedal washer link arm MAINTENANCE AND TROUBLE-SHOOTING This exercise bike is designed to be virtually maintenance-free. Inspect and tighten all parts periodically. Place the bike in a cool, dry location, out of direct sunlight. During extended periods of nonuse, the bike should be covered. If the electronic monitor appears to malfunction, the speed and power wires to the monitor should be checked. Remove the two screws attaching the monitor to the mounting bracket, and make sure that both wires are plugged fully into the back of the monitor. Reattach the monitor with the two screws. If the pulse earclip does not function properly, the problem may be solved by cleaning the earclip. Press the earclip open, and wipe the two clear bubbles inside the earclip, using a cotton swab saturated with denatured alcohol. If the range of pedaling resistance is too high or too low, it can be adjusted using the tension buckle located on the frame under the side shields. To raise the range of resistance, open the tension buckle, pull the resistance strap slightly tighter and close the buckle. To lower the range of resistance, open the buckle, loosen the strap slightly and close the buckle. resistance strapi5 tension buckle 10