Weslo Bench 200 Uk Manual - Page 6
Assembly
View all Weslo Bench 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Before you begin, make sure you have carefully read and fully understand the following information and instructions: • Assembly requires two people. • Place all parts of the weight bench in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • Read through each assembly step before beginning. • For help identifying the small parts used in assembly, refer to the PART IDENTIFICATION CHART on page 5. Note: Some small parts may have been pre-attached for shipping purposes. If a part is not found in the parts bag, check to see if it has been pre-attached. • As you assemble the weight bench, make sure that all parts are oriented exactly as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY: • two adjustable spanners • one Phillips screwdriver • one rubber mallet Lubricant, such as grease or petroleum jelly, and soapy water are also needed. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. If further assistance is needed, please call our Customer Service Department at 08457 089 009. 1. Before you begin, make sure you have read the instructions at the top of this page. Press the two 38mm Square Inner Caps (8) into the bottom of the "H"-Frame (1). Attach the two Upright Support Brackets (12) to the "H"-Frame (1) with four M8 x 55mm Bolts (14), four M8 Washers (25), and four M8 Nylon Locknuts (9) as shown. Make sure that the Upright Support Brackets are on the same side of the "H"-Frame as the highest part of the barbell rests (see the inset drawing). 2. Press a 30mm Square Inner Cap (27) into each end of the Stabiliser (3). Attach the Stabiliser (3) to the Main Frame (2) with the M8 x 47mm Bolt (15) and an M8 Nylon Locknut (9). Do not tighten the Locknut yet. 1 25 14 2 1 Barbell Rest 9 12 8 25 14 9 12 8 2 9 15 27 3 27 6