Weslo Bench 200 Uk Manual - Page 7

3. Attach the Main Frame (2) to the "H"-Frame (1) 3 with two M8 x 55mm Bolts (14) and two M8 Nylon Locknuts (9). Tighten the Locknut used in step 2. 14 2 9 1 4. Attach a Backrest Bracket (5) to the Backrest (6) with two M6 x 16mm Screws (13). Note: The holes in the Backrest are closer to the bottom of the Backrest. Attach the other Backrest Bracket (5) to the Backrest (6) with one M6 x 16mm Screw. Do not tighten the Screw yet. Slide the ends of both Backrest Brackets (5) onto the pin on the Main Frame (2) (see the inset drawing). Attach the free end of the Backrest Bracket (5) to the Backrest (6) with an M6 x 16mm Screw (13). Tighten all four Screws used in this step. 5. Attach the Seat (11) to the brackets on the Main Frame (2) with two M6 x 16mm Screws (13). (Note: The Screws may be pre-attached to the Seat.) 4 13 13 5 2 5 11 2 6 6 Pin 25 13 6. Attach the Weight Tube (19) to the Leg Lever (4) with the M8 x 42mm Bolt (22), two M8 Washers 6 (25), and the M8 Acorn Nut (24). 17-Lubricate Press a 25mm Round Inner Cap (21) into the indicated end of the Weight Tube (19). Press the 25mm Angled Cap (20) onto the other end of the Weight Tube. Slide the Weight Stop (30) onto the Weight Tube. Press a 30mm Square Inner Cap (27) into each end of the Leg Lever (4). Lubricate the M10 x 55mm Bolt (17). Attach the Leg Lever (4) to the Main Frame (2) with the Bolt and the M10 Nylon Locknut (23). Do not overtighten the Nylon Locknut; the Leg Lever must pivot freely. 7 4 27 24 21 25 30 19 27 20 22 23 2