Weslo Cadence 715 Treadmill Uk Manual - Page 11
Weslo Cadence 715 Treadmill Manual
View all Weslo Cadence 715 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
b. If the speed display does not show a correct reading, remove the key and UNPLUG THE POWER CORD. Remove the screws from the sides and front of the hood. Carefully remove the hood. Locate the reed switch and the Magnet (75) on the left side of the Pulley (43). Turn the Pulley until :tic Magnet is aligned with me Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 3 mm (1/8"). If necessary, loosen the Screw (24) and move the Reed Switch slightly. Retighten the Screw. Reattach the hood and run the treadmill for a few minutes to check for a correct speed reading. V STORAGE Unplug the power cord when the treadmill is not in use. Remove the bolt, washer and nut from the lower end of each handrail. Remove Remove the bolt from the upper end of each handrail. 3 mm Reed Switch 43 75 24 Top 0 View Remove Remove the bolt and washer from the lower end of the upright. Lay the upright on tile treadmill. Keep all_ bolts and washers in a secure location. Remove -• Remove the batteries from the console and cover the treadmill during extended periods of storage. 11