Weslo Eclipse 2 Elliptical User Manual - Page 7
Press two Bushings 39 into the Left Pedal Leg 3
View all Weslo Eclipse 2 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Slide a Handlebar Spacer (46) onto the left axle on the 4 Upright (2). Make sure that the open side of the Handlebar Spacer is facing the Upright. Make sure that there are two Bushings (39) in the Left Handlebar. Slide the Left Handlebar onto the left axle on the Upright (2). Tap a 5/8" Axle Cap (43) onto the axle. Repeat this step to attach the Right Handlebar (not shown). 6 Feed the Resistance Cable (33) up into the Upright (2) to form a loop as shown. Insert the tab on the Cable Cover (53) into the indicated slot in the Upright. Attach the Cable Cover with an M4 x 16mm Screw (42). 5. Tighten the three M4 x 38mm Screws (4) on each side of the Side Shield (27). Press two Bushings (39) into the Left Pedal Leg (3) as shown. Insert a Pedal Bolt (8) into the Pedal Leg. Tighten the Pedal Bolt into the left Crank Arm (10). Tighten a 1/2" Nylon Locknut (9) onto the Pedal Bolt. If the these parts are not tight the product may be damaged. Repeat this step to attach the Right Pedal Leg (not shown). 43 5 3 6. Plug the Extension Wire (49) into the socket in the back of the Console (52). Feed the wire down into the 6 Upright (2). Attach the Console (52) to the Upright with four M4 x 18mm Screws (69). Be careful to avoid pinching the wire. The Console (52) requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, first slide up the Battery Cover (60) and carefully remove the battery clip from the Console (52). Insert two batteries into the battery clip as shown. Make sure that the negative ends of the batteries (marked "-") are touching the springs in the battery clip. Replace the battery clip and close the Battery Cover. 49 69 2 Loop Slot 33 53 42 2 46 39 27 9 10 39 8 4 60 Batteries 52 Battery 52 Clip 69 7. Make sure that all parts of the ECLIPSE II are properly tightened. To protect the floor or carpet from damage, place a mat under the ECLIPSE II. 7