Weslo Portable Spa Canadian English Manual - Page 11

8. Before you fill the DAYBREAK, be sure that it is in 8 the position you want, and that it can be easily ser- viced, if needed. Once the DAYBREAK is filled with water, it will need to be drained to be moved. Using a garden hose or other clean water source, begin filling the DAYBREAK. Be sure to check for wrinkles, which may form in the Spa Liner (9) as 12 9 the water begins to cover the bottom. It is very important that you remove as many wrinkles from 13 the floor and sides of the DAYBREAK as possible. To do this, you should smooth any wrinkles out toward the sides, and then smooth the wrinkles to the top. It is normal to have some wrinkles around the Spa Jet Unit (13). Continue to fill the DAYBREAK, until the jet and filter openings on the Spa Jet Unit (13) are covered with water. Do not fill the DAYBREAK above the bottoms of the Edge Protectors (12). After the DAYBREAK is full, you must prime the Spa Jet Unit (13) before using the DAYBREAK (see PRIMING THE SPA JET UNIT on page 12). 9. Insert the Support Ball (58) into the mesh pocket on the underside of the Spa Cover (11). 9 11 See inset drawing A. Insert the inflation tube into the hole in the Support Ball (58). Inflate the Support Ball. See inset drawing B. When the Support Ball (58) is inflated, remove the inflation tube from the Support Ball and insert the ball plug through the mesh into the Support Ball. The head of the ball plug will hold the Support Ball in place. Note: The Support Ball (58) is not a toy. A Inflation Tube Mesh Pocket 58 B Ball Plug 58 58 11