Weslo Portable Spa Canadian English Manual - Page 15

SPA JET UNIT OPERATION The spa jet unit features five hydro-therapy jets, a whirlpool diverter, a suction vent, and a filter housing. The five hydro-therapy jets (A), located on the front of the spa jet unit, focus the water massage on your neck and back. B A ing the water for twenty minutes to filter any impurities. Also, if the water temperature falls below 40°F, the pump will begin circulating and heating the water to prevent the water from freezing. DRAINING THE DAYBREAK To drain the DAYBREAK, you must use a garden hose to siphon the water. Place one end of the hose in the DAYBREAK and hold it in front of a hydro-therapy jet until there is a flow of water coming out of the hose. Turn off the spa unit and unplug the power cord. The unit will be damaged if it is run without water circulating. Be sure the end of the hose in the DAYBREAK is on the floor of the spa. D C The whirlpool diverter (B), located on the left side of the spa jet unit, directs the flow of the water to create a whirlpool action in the DAYBREAK. The suction vent (C), located on the right side of the spa jet unit, pulls the water into the spa unit, in order to operate the system. The suction cover should always be in place over the suction vent. Never operate the DAY- BREAK without the C suction cover in place. The filter (D), is locat- ed on the left side of 57 the spa jet unit, behind the Filter Cover (47). The filter 47 can be removed for cleaning and replace- D ment by removing the Filter Cover and the two Filter Cover Screws (57) and then pulling the filter from the spa jet unit. The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been operated for three hours, the pump will begin circulat- DRAINING THE PUMP After the DAYBREAK is drained (see DRAINING THE DAYBREAK above), the Pump pump in the spa jet unit should also be drained if the DAY- BREAK will be stored for more than thirty days, or if it may be exposed to freezing temperatures. Drain Plug To drain the pump, remove the spa jet unit from the side panels. Be careful not to tear the spa liner. Locate the pump inside the spa jet unit. Remove the indicated bolt from the pump. Tip the spa jet unit slightly, until all the water has drained from the pump. Replace the drain plug. 15