Weslo Portable Spa Canadian English Manual - Page 18
Wiring Diagram
View all Weslo Portable Spa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
10. SYMPTOM: THE SPA JET UNIT CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. To turn the spa jet unit on, press the ON/OFF control once. To turn the spa jet unit off, press the control twice. After you press it once, the spa jet unit will shut off for about 30 seconds, and restart. Press the control again. The spa jet unit will remain off for three hours, at which time it will begin running the filter cycle. At any time after the spa jet unit has been shut off, the pump will begin cycling the water if the temperature falls below the minimum setting. 11. SYMPTOM: THE WATER LEVEL DROPS a. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wetness on the floor around the DAYBREAK, then the liner may have a leak. Locate the leak, and patch it using a pool patch kit that you can purchase at any pool and spa supply store. b. A clamp or seal inside the spa jet may be loose. Check the floor around the spa jet unit for excess water, and watch the spa jet unit while it is operating to see if water drips from the spa jet unit housing. If you can identify the location of the leak inside the spa jet unit, tighten the clamp or replace the damaged seal. 12. SYMPTOM: THERE ARE WRINKLES IN THE LINER a. Drain the water from the DAYBREAK, until the water level is below the wrinkles. Smooth out any wrinkles that you can see. Begin to refill the DAYBREAK. Be sure to check for new wrinkles that may form in the spa liner as the water begins to cover the bottom. Smooth out any wrinkles toward the sides, and then smooth the wrinkles to the top. It is normal to have some wrinkles around the spa jet unit. WIRING DIAGRAM POWER SUPPLY BLACK/HOT GFCI WHITE/NEUTRAL TIMER GROUNDING CONDUCTOR/LUG (Pressure Wire Connector) GREEN/GROUND MOTOR See the manufacturer's wiring diagram on the pump motor for more information. 18