Weslo Portable Spa Canadian English Manual - Page 16
Maintenance
View all Weslo Portable Spa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
MAINTENANCE CLEANING THE SPA LINER The liner should be cleaned with a mild soap solution. Do not use solvents. The liner should always be clean and dry before being moved or stored. CHECKING AND CLEANING THE FILTER The filter should be checked periodically for build-up of dirt and oil. If the filter needs to be cleaned, follow the steps below: 1. Turn off the power. 2. Remove the filter from the spa jet unit by pulling the white filter from the side of the spa jet unit. 3. Check the filter for any dirt or debris. If the filter needs to be cleaned, rinse the filter with a hose. If the filter still is dirty, you will need to soak it in a cleaning solution which can be obtained from a pool and spa supply store. 4. Inspect the filter for damage. Replace the filter if there are any signs of damage. 5. Re-insert the cleaned filter into the spa jet unit. MAINTAINING THE SPA COVER The spa cover should be cleaned monthly. To clean the spa cover, hang it over a clothes line and spray it with a hose. Leave the cover on the clothes line until it is fully dry. WINTER USE AND CARE The DAYBREAK is designed for year-round use. If you decide to store the DAYBREAK for the winter, store it in a warm, dry location. (See DRAINING THE DAYBREAK and DRAINING THE PUMP on page 15.) WATER CHEMISTRY 4. Keep all chemicals out of the reach of children and pets. 5. Keep all containers closed tightly when not in use. 6. Never add water to the chemicals-always add the chemicals to the water as directed. 7. Always store chemicals in a cool, dry place. 8. Always keep chemicals away from chil- dren and pets. MAINTAINING THE PROPER PH BALANCE The pH factor is a measure of relative acidity or alkalinity in the water. It is measured on a scale of 1 to 14. Pure water has a value of 7, which is neutral. Any value above 7 is alkaline, and any value below 7 is acidic. You should maintain a slightly alkaline pH level, between 7.2 and 7.8, in the DAYBREAK. Severe problems can occur when the pH balance is not maintained within this range. If the pH level exceeds 7.8, dissolved minerals can build-up and clog the plumbing in the spa jet unit. If the pH level falls below 7.2, the acid level in the water will begin to corrode the metal parts in the spa jet unit. Also, the sanitation agents in the water will not be effective if the pH level is not properly maintained. Damage caused by improper pH levels is not covered under the warranty. To maintain the proper pH level, you should test the pH of the water regularly. You will need a pH test kit (not included), which can be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8. If the level is too low, add a pH increaser (usually soda ash). If the level is too high, add a pH reducer (usually sodium bisulfate). Test the water again after five minutes. See the instructions with your pH test kit for additional information about testing and adjusting the pH. The DAYBREAK comes with a starter chemical pack for maintaining the water in the spa. (See TESTING AND TREATING THE WATER on page 13.) Additional chemicals can be purchased at a pool and spa supply store. SANITIZING THE DAYBREAK Please refer to your local pool and spa supplier for information concerning which chemicals you should use in your area to sanitize the spa. CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous. Always follow these basic guidelines when handling the chemicals: 1. Always read and follow the directions on the label, unless directed otherwise. 2. Never mix different chemicals. 3. Do not exceed the recommended amounts-follow the directions on the label closely. The most common sanitizing agent is a solid bromine concentrate. The amount required varies according to several factors, such as user load, temperature, water conditions, and so forth. Proper water maintenance is a fairly complex process. We recommend that you contact your local pool and spa supplier for information on how you should best accomplish this. 16