Weslo Pursuit 616s Bike English Manual - Page 7
the Seat Pin under the Seat Post.
![]() |
View all Weslo Pursuit 616s Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Attach the Handlebar (4) to the Handlebar Post (2) 5 with two M10 x 19mm Button Head Screws (25) and two M10 Split Washers (26). 2 6. Insert the Seat Post (3) into the Frame (1). Press the Seat Post Shield (30) down onto the Frame. 6 Align one of the holes in the Seat Post (3) with the hole in the Frame (1). Turn the Seat Pin (14) as shown and insert it fully into the Frame and the Seat Post. Make sure to insert the Seat Pin through one of the holes in the Seat Post; do not insert the Seat Pin under the Seat Post. Attach the Seat (16) to the Seat Post (3) with three M8 Nylon Locknuts (24) and three M8 Split Washers (41). Note: The Nylon Locknuts and Split Washers may be pre-attached to the bottom of the Seat. 41 24 30 1 4 25 26 16 41 24 3 14 7. Identify the Left Pedal (45) (there is an ÒLÓ on the Left Pedal for identification). Using an adjustable wrench, tighten the Left Pedal counterclockwise into the left arm of the Crank (29). Tighten the Right Pedal (not shown) clockwise into the right arm of the Crank. Tighten both Pedals as fully as possible. Important: After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept properly tightened. Adjust the Left Pedal Strap (34) to the desired position. Press the Left Pedal Strap onto the adjustment tab on the Left Pedal (39). Adjust the Right Pedal Strap (not shown) in the same way. 7 34 29 45 Tab 7
![](/manual_guide/products/weslo-pursuit-616s-english-manual-375b3f5/7.png)