Weslo Pursuit 618s English Manual - Page 12

MAINTENANCE AND TROUBLE-SHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. The exercise cycle can be cleaned with a soft, damp cloth. Avoid spilling liquid on the console. Keep the console out of direct sunlight or the display may be damaged. Remove the batteries when storing the exercise cycle. HOW TO TIGHTEN THE CRANK If the arms of the Crank (33) become loose, they should be tightened in order to prevent excessive wear. Loosen the crank nut on the left arm of the Crank. Place the end of a standard screwdriver in one of the slots in the slotted crank nut. Lightly tap the screw- driver with a hammer to turn the slotted crank nut Crank Nut Slotted Crank Nut counterclock- wise until the arms are no 33 longer loose. Do not over- tighten the slotted crank nut. When the slotted crank nut is properly tightened, retighten the crank nut. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. To replace the batteries, see assembly step 2 on page 6. In addition, make sure that the console wire is connected to the reed switch wire. HOW TO ADJUST THE PEDAL STRAPS To adjust the Right Pedal Strap (4), first pull the Pedal Strap off the tab on the pedal. Align a different hole in the Pedal Strap with the tab. Press the Pedal Strap back onto the tab. Adjust the Left Pedal Strap (not shown) in the same manner. 4 Tab HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. In order to adjust the reed switch, the Left Side Shield (1) must be removed. Using an adjustable wrench, turn the Left Pedal (28) 40 34 33 28 34 34 1 26 clockwise and remove it from the Crank (33). Remove the two M4 x 12mm Screws (26) and the three M4 x 38mm Self-tapping Screws (34) from the Left Side Shield. Next, lift the Side Shield Cover (40) off the Side Shields. Grasp both Side Shields at the top and gently pull them apart. Make sure that the arm of the Crank is in the position shown in the drawing above. Carefully slide the Left Side Shield forward off the arm of the Crank and remove it. Next, locate the Reed Switch (50). Turn the Crank (33) 9 until the Magnet (51) is aligned with the 51 Reed Switch. 33 Loosen but do not remove the M4 x 16mm Self-tapping 50 Screw (9). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console displays cor- rect feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the pedal. 12