Weslo Pursuit 618s English Manual - Page 9

HOW TO OPERATE THE CONSOLE 1. To turn on the power, press the mode button or simply begin pedaling. When the power is turned on, the entire display will appear for two seconds. The console will then be ready for operation. USING THE PULSE SENSOR To use the pulse sensor, first plug the pulse sensor wire into the jack at the lower edge of the console, as shown in the drawing at the right. Console Sensor Wire 2. Select the desired mode: Scan modeÑWhen the power is turned on, the scan mode will automatically be selected. The ÒAÓ mode indicator will show that the scan mode is selected, and a flashing mode indicator will show which mode is currently displayed. Note: If a different mode is selected, you can select the scan mode again by repeatedly pressing the mode selector button. Speed (S), distance (D), time (T), odometer (O), calorie (C), or pulse (h) modeÑTo select one of these modes for continuous display, press the mode button repeatedly. The mode indicators will show which mode is selected. Make sure that the scan (A) mode is not selected. 3. To reset the display, press the mode button and hold it for more than two seconds. 4. To turn off the power, simply wait for about four minutes. Note: The console has an Òauto-offÓ feature. If the pedals are not moved and the monitor button is not pressed for four minutes, the power will turn off automatically in order to conserve the batteries. Next, attach the pulse sensor wire to your col- lar or another suitable place on your clothing. Pulse Sensor Rub your left ear lobe several times with your thumb and index finger and then Collar clip the pulse Clip sensor onto your ear lobe. Push the mode button until a heart- shaped indicator appears on the right side of the dis- play. Your heart rate will appear after approximately four seconds. Note that the pulse sensor is more accurate when worn on the left ear lobe and when you are sitting still. It is recommended that you stop pedaling when using the pulse sensor for best results. If your heart rate does not appear on the display after four seconds, make sure that the pulse sensor wire is fully plugged into the console. If you still donÕt get a reading, make sure the pulse sensor is attached properly. It is often difficult to position the pulse sensor on the first try, so you may have to reposition it a few times before you find the best position. It may be helpful to use a mirror or a friend to find the correct position for the pulse sensor. When you have gotten an accurate pulse reading, switch to another mode to conserve battery power. 9