Weslo Pursuit 618s English Manual - Page 7

4. Attach the Handlebar (5) to the Handlebar Post (14) with two M10 x 25mm Button Screws (8) and two 4 M10 Split Washers (41). 8 41 5. Insert the Seat Post (20) into the Frame (15). Press 5 the 38.1mm x 63.5mm Bushing (23) into the Frame. Align one of the holes in the Seat Post with the hole in the Frame. Insert the Seat Knob (29) into the Frame and the Seat Post, and tighten the Seat Knob into the Frame. Make sure to insert the Seat Knob through one of the holes in the Seat Post; do not insert the Seat Knob under the Seat Post. Attach the Seat (19) to the Seat Post (20) with three M8 Nylon Locknuts (21) and three M8 Split Washers (49). Note: The Nylon Locknuts and Split Washers may be pre-attached to the bottom of the Seat. 5 14 19 49 21 23 49 21 20 29 15 6. Identify the Left Pedal (28); there is an ÒLÓ on the Left Pedal for identification. Using an adjustable 6 wrench, tighten the Left Pedal counterclockwise into the left arm of the Crank (33). 33 Tighten the Right Pedal (not shown) clockwise into the right arm of the Crank (33). 28 7. Make sure that all parts are tightened before you use the exercise cycle. Note: There may be some hardware left over after assembly is completed. Place a mat under the exercise cycle to protect the floor or carpet. 7