Weslo Pursuit 618s English Manual - Page 6

ASSEMBLY Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench adjustable wrenches . , a phillips screwdriver and two 1. Identify the Front Stabilizer (17), which has Wheels (25) on the ends. Hold the Front Stabilizer (17) against the saddle on the front of the Frame (15). Make sure that the Front Stabilizer is turned so the square holes are facing away from the saddle. Attach the Front Stabilizer with two M8 x 65mm Carriage Bolts (30) and two M8 Nylon Locknuts (21). Attach the Rear Stabilizer (not shown) to the rear of the Frame (15) in the same manner. 2. The Console (7) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. Remove the Battery Cover (59), located on the underside of the Console. Press two batteries into the battery compartment. Make sure that the batteries are turned so the negative ends (marked ÒÐÓ) are touching the springs in the battery compartment. Reattach the Battery Cover. 1 30 25 2 7 17 25 15 21 Batteries 59 3. Carefully slide the Handlebar Post (14) onto the Frame (15). Be careful to avoid pinching the wires inside the Handlebar Post. Attach the Handlebar Post with three M10 x 25mm Button Screws (8) and three M10 Split Washers (41). Refer to the inset drawing. Thread the console wire down through the round hole in the console plate, into the hole in the right side of the Handlebar Post (14), and out the top of the Handlebar Post. Connect the console wire to the Reed Switch Wire (50). Attach the Console (7) to the Handlebar Post (14) by sliding the Console onto the indicated tab. Insert any excess console wire and Reed Switch Wire into the Handlebar Post. Attach the Knob Housing (12) to the Handlebar Post (14) with an M4 x 16mm Self-tapping Screw (9). 3 7 Console Console Wire Wire Console 7 Plate 50 Tab 14 14 Holes 12 9 41 8 15 8 41 8 6