Westinghouse MT80 ARM20 Installation Instructions - Page 2

Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Westinghouse product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call customer service at 1-866-287-5555. • This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions. • Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Never mount this product to a metal stud wall construction unless the stud can be verified to be constructed of 25 gauge steel minimum, the drywall is 1/2" thick minimum and you obtain and use the accessory kit for metal studs. • Never exceed the Maximum UL Load Capacity. • If mounting to wood wall stud wall construction, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended. • Always use an assistant or mechanical lifting equipment to safely lift and position equipment. • Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power. See suggested torque values where applicable within these instructions. Tools Needed for Assembly • stud finder ("edge to edge" stud finder is recommended) • phillips screwdriver • drill with 1/4" and 5/32" drill bits Accessories • Metal Stud Wall Plate (WSP models) (Not evaluated by UL) Table of Contents Parts List ...3 Installation to Wood Stud Wall ...4 Installation to Solid Concrete and Cinder Block ...5 For customer care call 1-866-287-5555. 2 of 10 ISSUED: 01-17-06 SHEET #: 202-9094-1