Westinghouse MT80 ARM20 Installation Instructions - Page 4

Installation to Wood Stud Wall WARNING • Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components. 1 Remove cord covers from wall arm assembly (A) as shown in figure 1.1. Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (65 mm) deep. Attach wall mount (A) to wall using two #14 x 2.5" flat head wood screws (H) as shown in figure 1.2. Skip to step 2 on page 6. WARNING • Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in. • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended. CORD COVER fig. 1.1 A WOOD STUD WALL H A fig. 1.2 4 of 10 ISSUED: 01-17-06 SHEET #: 202-9094-1