Westinghouse MT80 ARM20 Installation Instructions - Page 7

FOR VESA 100 MOUNTING PATTERN: Thread two M4 x 12 mm screws (E), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto adapter plate, and attach using bottom two M4 x 12 mm screws as shown in figures 2.4 and 2.5. Tighten all four screws. *Note: If screw (E) gets less than three threads of engagement, attach adapter plate to back of screen using four M4 x 20 mm screws (F) as indicated in figure 2.5. FOR VESA 200 MOUNTING PATTERN: Thread two M4 x 12 mm screws (E), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto adapter plate, and attach using two bottom M4 x 12 mm screws as shown in figures 2.4 and 2.5. Tighten all four screws. *Note: If screw (E) gets less than three threads of engagement, attach adapter plate to back of screen using four M4 x 20 mm screws (F) as indicated in figure 2.5. FOR VESA 200 x 200 MOUNTING PATTERN: Thread two M6 x 12 mm screws (G), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto adapter plate, and attach using two bottom M6 x 12 mm screws as shown in figures 2.4 and 2.5. Tighten all four screws. FOR SHARP™ 37" LCD SCREEN MODELS LC-37HV6U AND LC-37HV4U: Thread two M6 x 20 mm screws (J), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto adapter plate, and attach using two bottom M6 x 20 mm screws as shown in figures 2.4 and 2.5. Tighten all four screws. FOR SHARP™ 45" LCD SCREEN MODEL LC-45GX6U: Thread two M6 x 30 mm screws (K), leaving .25" exposed thread, into top holes on back of screen. Hook screen onto adapter plate, and attach using two bottom M6 x 30 mm screws as shown in figures 2.4 and 2.5. Tighten all four screws. SCREW fig. 2.4 ADAPTER PLATE fig. 2.5 ADAPTER PLATE SCREW *For screens with a hole pattern in a pocket, spacers (C) go between C adapter plate and screen. 7 of 10 ISSUED: 01-17-06 SHEET #: 202-9094-1