Whirlpool DU1055XTVB Installation Instructions - Page 3

INSTALLATION REQUIREMENTS Tools and Parts Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. All Installations Tools needed: In addition, for first time installations Tools needed: Cordless drill with and 1¹⁄₂" hole saw bits Small tubing cutter Wire stripper Pliers Phillips screwdriver nut drivers or hex sockets Flat-blade screwdriver Utility knife UL Listed/CSA Approved twist-on wire connectors* Parts needed: Copper tubing (³⁄₈" O.D. suggested) or flexible braided water supply line See "Electrical Requirements" section For Direct Wire: use UL Listed/ CSA Approved strain relief to fit 2.2 cm) hole For Power Supply Cord: use UL listed power supply cord kit marked for use with dishwasher Measuring tape or ruler Small level 10" adjustable wrench that opens to wrench *Must be the proper size to connect your household wiring to 16 gauge wiring in dishwasher Other useful items you may need: Flashlight Bath towel Shallow pan Wood block Parts supplied: Drain hose clamps (2) (1 large and 1 small) Drain hose Phillips-head screws (2) Silver Green Make sure all these parts are included in the literature package. Parts needed: Other parts you may also need: (38.1- 5 cm) Screw-type clamps (3 maximum) Side mounting kit for solid surface countertops (Part Number 8212560) Masking or duct tape NOTE: Parts available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer. Location Requirements Grounded electrical supply required. Do not run drain lines, water lines or electrical wiring where they can interfere with or contact dishwasher motor or legs. The location where the dishwasher will be installed must provide clearance between motor and flooring. Motor should not touch the floor. Do not install dishwasher over carpeted flooring. Shelter dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty. A side panel kit is available from your dealer for installing your dishwasher at the end of your cabinetry. A moisture barrier accessory (Part Number 4396277) is available from your dealer for installing underneath the countertop. Check location where dishwasher will be installed. The location must provide: • easy access to water, electricity and drain. • Convenient access for loading and unloading dishes. Corner locations require a 2" (5.1 cm) minimum clearance between the side of the dishwasher door and the wall or cabinet. • square opening for proper operation and appearance. • cabinet front perpendicular to floor. • level floor. (If floor at front of opening is not level with floor at rear of opening, shims may be needed to level dishwasher.) Helpful Tip: Be sure to accurately measure dimensions and ensure dishwasher is level if the floor in the dishwasher opening is uneven (example: flooring extends only partway into opening). NOTE: To avoid shifting during dishwasher operation, shims must be securely attached to the floor. If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it winterized by authorized service personnel. Make sure pipes, wires and drain hose are within the shaded area shown in the "Product and Cabinet Opening Dimensions" section. 3