Whirlpool DU1055XTVB Installation Instructions - Page 9

3 Connect drain hose Connect drain hose to waste tee or waste disposer using one of the following options: • Option A, Waste disposer - no air gap • Option B, No Waste disposer - no air gap • Option C, Waste disposer - with air gap • Option D, No waste disposer - with air gap IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Helpful Tip: To reduce vibration of the hose, keep the hose away from the floor. Option A, Waste disposer - no air gap Waste disposer - no air gap Disposer inlet Large silver drain hose clamp Drain hose Drain trap 1 1. Using a hammer and screwdriver, knock plug into disposer. 2 2. Use needle-nose pliers to remove plug. 3. Attach drain hose to disposer inlet with 3 large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. Option B, No waste disposer - no air gap No waste disposer - no air gap SLcarregwe-stiylvpeer drain chloamsepclamp Waste tee Drain hose 1 Black end 2 Drain trap 1. Connect black end of of drain hose to waste tee and cut if needed. NOTE: Do not cut ribbed section. 2. Attach black end of drain hose to waste tee with a large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided). Option C, Waste disposer - with air gap Waste disposer - with air gap Screw-type clamps Disposer inlet Air gap Large silver drain hhoossee ccllaammpp (provided) Rubber hose connector Drain hose Drain trap 1 1. Using a hammer and screwdriver, knock plug into disposer. 2 2. Use needle-nose pliers to remove plug. 3 Black end 3. Connect black end of drain hose to air gap and cut if needed. NOTE: Do not cut ribbed section. 4. Attach drain hose to air gap with large 4 silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided). 5 5. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. Option D, No waste disposer - with air gap No waste disposer - with air gap Screw-type clamps Waste tee Air gap Large silver drain hose clamp (provided) Rubber hose connector Drain hose 1 Black end 2 3 Drain trap 1. Connect black end of drain hose to air gap and cut if needed. NOTE: Do not cut ribbed section. 2. Attach drain hose to air gap with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided). 3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. 9