Whirlpool GCEM2990TQ Installation Instructions - Page 13
PowerSupplyCord, Three=wirelectricalconnection
View all Whirlpool GCEM2990TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
PowerSupplyCord, Three=wirelectricalconnection; This blade connected to B D C A. Spade terminals with upturned ends B. Ring terminals C. Neutral (white or center) D. 3/4"UL-listed strain relief E. Neutral Three-wire power supply cord must have three, No.-10 copper wires and match a three-wire receptacle of NEMA Type 10-30R. Use this method where local codes permit connecting neutraB ground wire to neutrat wire: 5, Loosen or remove the center terminal block screw. 6, Connect the neutral wire (white or centeO of the power supply cord to the center, siIver-co!ored terminal screw of the terminal block, Tighten screw, 7° Connect the other wires to outer terminal block screws, Tighten screws, 8, Tighten strain relief screws, 9, Insert tab of the terminal block cover into slot of the dryer rear panel, Secure cover with hold-down screw, D .......... c ...1..1.'.!i, A. External ground conductor screw B. Center terminal block screw C, Outer terminal block screws D, Strain relief screw E. Neutral (center wire) F, Appliance neutral ground wire Use this method where mocal codes do not permit connecting neutrat ground wire to neutral wire: 5, Remove the center terminal block screw, 6, Remove the appliance neutral ground wire from the external ground conductor screw, Connect the appliance neutral ground wire and the neutral wire (white or center) of the power supply cord under the center, silver-colored termina! block screw, Tighten screw, 7, Connect the other wires to outer terminal block screws, Tighten screws, 8, Tighten strain relief screws, 9, Insert tab of the terminal block cover into slot of the dryer rear panel, Secure cover with hold-down screw, 10, After reattaching the terminal cover, connect a separate copper ground wire from the external ground conductor screw to an adequate ground, If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate, A. Separate copper ground wire B, External ground conductor screw C, Appliance neutral ground wire D. Center terminal block screw E. Outer terminal block screws F. Strain relief screw G. Neutral (center wire) 13