Whirlpool GCEM2990TQ Installation Instructions - Page 7

,ilii;i;!_!!i!i_i!i!i?:_!?ii!;i!!_/_:i¸%_ i!:_i ?i i:!_i_:iil:i_!i_:;ii_!!fi; Explosion Hazard Use a new CSA gnternational approved gas supply mine. Install a shut-off valve. Securely tighten all gas connections. ff connected to LP, have a quamified person make sure gas pressure does not exceed 14" (36 cm) water comumn. Exampmes of a qualified person include: licensed heating personnel, authorized gas company personnem, and authorized service personnel Failure to do so can result in death, expmosion, or fire. IMPORTANT: Observe all governing codes and ordinances. This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1/NFPA 54. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park, Quincy, MA 02269 The design of this dryer has been certified by CSA International for use at altitudes up to 10,000 feet (3048 m) above sea level at the B.T.U. rating indicated on the model/serial plate. Burner input adjustments are not required when the dryer is operated up to this elevation. When insta!led above 10,000 feet (3048 m), a four percent (4%) reduction of the burner B.T.U. rating shown on the model/serial plate is required for each 1,000 foot (305 m) increase in elevation. For assistance when converting to other gas types and/or installing above 10,000 feet (3048 m) elevation, contact your local service company. Gas Suppty Line Recommended method [] Provide a gas supply line of 1/2"rigid (IPS) pipe to the dryer location. Pipe joint compounds that resist the action of LP gas must be used. Do not use TEFLON _t tape. With LP gas, piping or tubing size can be 1/_,m, inimum. Usually, LP gas suppIiers determine the size and materials used in the system. A_temate method [] The gas supply may also be connected using %" approved copper or aluminum tubing. If the total Iength of the supply line is more than 20 feet (6.1 m), Iarger tubing will be required. If using natural gas, do not use copper tubing. Pipe joint compounds that resist the action of LP gas must be used. F_exib_e meta_ appliance connector: [] It is recommended that a new flexible stainless steel gas line, design-certified by CSA International, be used for connecting the dryer to the gas supply line. (The gas pipe which extends through the lower rear of the dryer is provided with %" male pipe thread.) [] Do not kink or damage the flexible stainless steel gas line when moving the dryer. Rigid pipe connection: The rigid pipe connection requires a combination of pipe fittings to obtain an in-line connection to the dryer. [] Must include a shutoff valve: The supply Iine must be equipped with a manual shutoff valve installed within 6 ft. (1.8 m) of dryer in accordance with National Fuel Gas Code, ANSI Z223.1. This valve should be located in the same room as the dryer. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the dryer. B Type of Gas This dryer is equipped for use with natural gas. It is designcertified by CSA International for L.R (propane and butane) gases with appropriate conversion. No attempt shall be made to convert the dryer from the gas specified on the serial/rating plate for use with a different gas without consulting the serving gas supplier. Conversion must be done by a qualified service technician. Gas conversion kit part numbers are listed on the gas valve burner base. A A. Gas supp!y line B. Shutoff valve "open" position C. To dryer [] Installed in a confined area: If the dryer is installed in a confined area such as a bathroom or closet, provision must be made for enough air for combustion and ventilation. Check governing codes and ordinances or refer to the "Recessed Area and Closet Installation Instructions" in the "Location Requirements" section t@TEFLON is a registered trademart_ of E,I, Du Pont De Nemours and Company, 7