Whirlpool LRF4001RY Use and Care Manual - Page 4
Installation Requirements, Warning - instructions
View all Whirlpool LRF4001RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION REQUIREMENTS Location Requirements Electrical Requirements WARNING WARNING NEW 2 PRONG PANEL Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from fabric freshener. Place fabric freshener at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. The Fabric Freshener will require an area large enough to set up the Fabric Freshener and to load. 57¹⁄₈" (145.1 cm) Fire Hazard Do not use an extension cord. Doing so can result in death, or fire. Electrical Connection To properly install your Fabric Freshener, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. s The Fabric Freshener should be connected to a 120 volt, 60 Hz, 15- or 20-amp fused 2 prong polarized outlet. s Electrical consumption: at $0.04 (approximate) per cycle, 150 cycles per year = $6 per year (approximate). Usage and costs may vary. s The Fabric Freshener uses just under ¹⁄₂ kwh. Maximum amp draw is limited to 80% of a 15-amp circuit, or 12 amps, at 120 volts. 80% is equal to 1,440 watts of 1,800 watts available on a 15-amp circuit. If house wiring is less than 120 volts, available wattages may be lower. Usage and costs may vary. 12" (30.48 cm) 32¹⁄₂" (82.55 cm) Installation Clearances Minimum clearances Sides and back of the Fabric Freshener s 0" (0 cm) clearance is acceptable. Front of the Fabric Freshener s 12"(30.48 cm) clearance is recommended. 4