Whirlpool UVL6036JSS Installation Instructions - Page 16

RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Replacing a Halogen Lamp Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water or all-purpose cleanser. ■ Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp. If new lamps do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Push up on the lens and turn it counterclockwise. Metal Grease Filter: 1. Remove each filter by pulling the spring release handle and then pulling down the filter. 2. Wash metal filters as needed in dishwasher or hot detergent solution. 3. Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track. 4. Push in spring-release handle. 5. Push up on metal filter and release handle to latch into place. 6. Repeat steps 1-5 for the other filter. 3. Remove the lamp and replace it with a 120 V, 50 W maximum halogen lamp with a GU10 base. Turn it clockwise to lock it into place. 4. Repeat steps 2-3 for the other lamp if needed. 5. Reconnect power. 16