Whirlpool WDT550SAPB Owners Manual - Page 12

Electrical Requirements Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70 - latest edition, and all local codes and ordinances. For a fee, a copy of the above code standards can be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, MA 02169-7471 You Must Have: � 120 V, 60 Hz, AC-only, 15 A or 20 A, fused electrical supply. � Copper wire only. � A maximum of 2 field wiring supply conductors (12 AWG largest size) plus 1 grounding conductor are permitted in the terminal box. � An included junction box for electrical connection. We Recommend: � Install the dishwasher on a circuit with appropriate interrupter per your local code. The dishwasher is compatible with time delay fuses, standard circuit breakers, and GFCI and AFCI circuit breakers. Circuit Requirement: � The dishwasher may be installed on the same circuit as a garbage disposal providing that the branch circuit cannot exceed rated circuit load and must comply with all governing codes and regulations such as but not limited to National Electrical Code, ANSI/NFPA 70 - latest edition. � No electrical connections other than the dishwasher power and ground connections can be made inside of the dishwasher junction box. If Connecting Dishwasher with a Power Cord: � Use a UL-listed power cord kit marked for use with dishwasher. See the "Tools and Parts" section for part details. � Plug into a grounded 3-prong outlet. Outlet must meet all local codes and ordinances. INSTALLATION INSTRUCTIONS WARNING Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. You Need To: � Slowly open the dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials. Place included parts and literature aside in a safe place for later. Close dishwasher door until latched. C D E B A If Connecting Dishwasher with Direct Wiring: � Use flexible, armored, or nonmetallic sheathed copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances. � Use only the supplied plastic cable fittings for flexible and non-metallic sheathed wiring (Romex, etc.). Do not use metallic strain reliefs for these wire constructions. � Use a UL-listed/CSA-approved metallic strain relief for armored cable installations (21 mm diameter) if using armored cable. Install the strain relief per the strain relief manufacturer's installation instructions. � Use a UL-listed/CSA-approved metallic strain relief for flexible metal conduit installations if using flexible metal conduit. Install the strain relief per the strain relief manufacturer's installation instructions. A. Cardboard box containing the Accessories B. Cardboard tube containing the Handle (on some models) C. 3/8" to 3/4" (9.5 mm to 19 mm) Water Inlet Adapter D. Assembly accessories E. Junction box IMPORTANT: Do not throw away the Cardboard box. It contains installation materials inside. NOTE: Each dishwasher is tested at the factory and may contain some residual water in the tub as a result of the test. � Observe all governing codes and ordinances. � Install this dishwasher as specified in these instructions. � The dishwasher must be installed to meet all electrical and plumbing national and local codes and ordinances. 12