Whirlpool WDT550SAPB Owners Manual - Page 7

Issue Dishwasher overfills Code Shown (7 Seg Display) (if present) F8E4 Code Shown on Front Panel LED * (# blinks, Pause, # blinks) 8 Pause 4 Pause - pause, repeat What will happen? Drain sequence will begin, machine operation will be prevented. Fill valve stuck on F8E5 Dishwasher will F9E1 not drain Variable Speed Drain Motor Fault - Locked Rotor or Not Primed F9E3 8 Pause 5 Pause - pause, repeat 9 Pause 1 Pause - pause, repeat Drain sequence will begin, machine operation will be prevented. Cycle ends. 9 Pause, 3 Pause - pause, repeat Cycle ends. What to do? For Professional Installers Turn off water to unit (if possible). Turn off power to unit. If the water cannot be turned off, DO NOT turn off power and keep door closed. Press Cancel key one time to silence alarm tone. Call service. For Self Installers � Press CANCEL button twice or cycle power. This may clear the issue. � Check to see if the wire connector is connected to the float switch on the drip tray. If the wire is off, reconnect and then hit the cancel button twice. � Check to see if there is any water in the drip tray. If water is in the drip tray, remove the water and reinstall the drip tray. Make sure to connect the wiring to the float. Check to see where water may have leaked into the drip tray (Check the water inlet fittings to see if they are leaking). � If water was in the tray and no leaks were found, run the product on the shortest installation cycle while checking for leaks. The access panel should be off to observe any leaks. � If problem still exists, call for service. Turn off water to unit (if possible).Turn off power to unit. If the water cannot be turned off, DO NOT turn off power and keep door closed. Press Cancel key one time to silence alarm tone. Call service. If drain hose is connected to a garbage disposal, confirm that drain hose is not clogged and disposal plug has been knocked out. If unit still will not drain, call service. Call service. 7