Whirlpool WDT550SAPB Owners Manual - Page 27
Option C: Waste disposer - with air gap, Option D: No waste disposer - with air gap
View all Whirlpool WDT550SAPB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Option C: Waste disposer - with air gap A G F E B D C A. Screw-type clamps B. Disposer inlet C. Drain trap D. Drain hose E. Rubber hose connector F. Drain hose clamp (black color) G. Air gap Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, knock plug into disposer. 2. Use needle-nose pliers to remove plug. 5. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. Option D: No waste disposer - with air gap A G F E B D C A. Screw-type clamps B. Waste tee C. Drain trap D. Drain hose E. Rubber hose connector F. Drain hose clamp (black color) G. Air gap 1. Connect rubber end (A) of drain hose to air gap and cut if needed. 3. Connect rubber end (A) of drain hose to air gap and cut if needed. A A. Two cut lines NOTE: Do not cut ribbed section. 4. Attach drain hose to air gap with drain hose clamp (black color) (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm)screw-type clamp (not provided). A A. Two cut lines NOTE: Do not cut ribbed section. 2. Attach drain hose to air gap with drain hose clamp (black color) (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw-type clamp (not provided). 3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. 27