Whirlpool WDT705PAK Owners Manual - Page 15

Place Dishwasher in Cabinet WARNING Excessive Weight Hazard Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other injury. 30. Stand dishwasher upright 32. Route power cord. If using a power cord, make sure to route end through hole in cutout before sliding dishwasher into cabinet opening. 33. Secure installation blanket Using 2 or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so. IMPORTANT: If wheels were removed, cover the floor when moving the dishwasher. Slowly move dishwasher completely into cabinet opening. Do not kink or pinch water line, drain hose, power cord, or direct wire between dishwasher and cabinet. Remove cardboard from under dishwasher. It is all right if dishwasher fits tightly into cabinet opening. Do not remove insulation blanket-the blanket reduces the sound level. NOTE: Route water supply, drain hose, and power cord out the rear of the dishwasher. 31. Move dishwasher close to cabinet opening NOTE: Make sure insulation blanket is secured at both left and right rear corners before pushing into cabinet opening to keep the blanket from bunching up in a tight-fitting cabinet. 34. Move dishwasher all but 6" (152 mm) into cabinet opening NOTE: Leave unit about 6" (152 mm) out from cabinet in order to install anchor brackets and adjust door tension if needed. 35. Pull slack from utilities Route the utilities through the holes in the cabinet and pull the slack out at the same time as the dishwasher is pushed into the cabinet. NOTE: Pull slack out of utilities at the same time the dishwasher is pushed into the cabinet opening to avoid any kinks. 15