Whirlpool WDT710PAYM Installation Guide - Page 11

Option D, No waste disposer - with air gap Prepare Dishwasher WARNING 1. Connect rubber end of drain hose to air gap and cut if needed. NOTE: Do not cut ribbed section. 2. Attach drain hose to air gap with large blue drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5.1 cm) screw-type clamp (not provided). 3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. NOTE: Insulation is provided on some models. If your model does not have insulation, proceed to Step 2. Install Moisture Barrier (under a wood countertop) Using the precut slots in the insulation, fasten the insulation over the molded hooks on the tub. Be sure to fasten the insulation down on both sides of the tub. 1. Make sure the area under the cabinet is clean and dry for installation of the moisture barrier. 2. Remove the backing of the moisture barrier and apply to underside of the countertop along the front edge of the counter. 11