Whirlpool WET3300XQ Installation Guide - Page 13

3. Connect ground wire 1. Remove center screw B F A Remove center terminal block screw (B). Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 2. Connect neutral wire B 4. Connect remaining wires C Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." 3-wire Power Supply Cord Connection IMPORTANT: Use where local codes permit connecting cabinet-ground conductor to neutral wire. Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3-prong plug Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Spade terminals with upturned ends Ring terminals 13