Whirlpool WET3300XQ Installation Guide - Page 23
Level Washer/dryer
View all Whirlpool WET3300XQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Level Washer/DRYER IMPORTANT: Level washer/dryer properly to reduce excess noise and vibration. 1. Check levelness of washer/dryer 3. Tighten leveling feet Jam nut Place level here Place level here With washer/dryer in its final location, place a level on top edges of washer/dryer. Use side seam as a guide to check levelness of sides. Check levelness of front using lid, as shown. Rock washer/dryer back and forth to make sure all four feet make solid contact with floor. If washer/dryer is level, skip to step 2. When washer/dryer is level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer/dryer cabinet. HELPFUL TIP: You may want to prop washer/dryer with a wooden block. In U.S.A. Not Level LEVEL 2. Adjust leveling feet Not Level Jam nut If washer/dryer is not level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts clockwise on feet until they are about 1/2" (13 mm) from the washer/dryer cabinet. Then turn the leveling foot clockwise to lower the washer/dryer or counterclockwise to raise the washer/dryer. Recheck levelness of washer/dryer and repeat as needed. HELPFUL TIP: You may want to prop up front of washer/dryer about 4" (102 mm) with a wood block or similar object that will support weight of washer/dryer. 4. Plug into a grounded 3- or 4- prong outlet 23