Whirlpool WET3300XQ Installation Guide - Page 22
Connect Vent, Connect Inlet Hoses
View all Whirlpool WET3300XQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connect Inlet Hoses 6. Check for leaks Connect vent 1. Connect vent to exhaust outlet Turn on water faucets to check for leaks. A small amount of water may enter washer. It will drain later. 7. Secure drain hose Laundry Tub Standpipe Wall 4.54".5" (113 mm) 4.5" (113 mm) 4.5" (113 mm) Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp. 2. Move washer/dryer to final location Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with shipping strap removed earlier. Move washer/dryer to final location, taking care not to crush or kink vent. After washe/dryer is in place, remove corner posts and cardboard from under washer/dryer. 22