Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 124

Technical information Stock satisfaction guides Stock Size Weight Capacity Type or condition Stock Size Table 7-5. Satisfaction guide for paper trays 1 and 2 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives 8 x 10 inches to 9 x 14 inches (203 x 254 mm to 229 x 356 mm) Stock smaller than 8 x 10 inches cannot be used. For stock larger than 9 x 14 inches (229 x 356 mm), refer to the tray 3 satisfaction guide. Substance 20 to 110 (75 to Substance 16 to 19 (60 to 72 Weights outside the limits 200 g/m2) g/m2) shown are not recommended. Substance 110 (200 g/m2) must be long grain. Do not use short grain. Tray 1 - 1100 sheets, substance 20 (75 g/m2) For greater capacity, use Tray 3. Tray 2 - 600 sheets, substance 20 (75 g/m2) Xerographic bond paper in good condition Drilled stock, fanned thoroughly Tab stock in perfectly flat condition Slightly curled paper Intermixed weights Transparencies Label stock Adhesive drafting film Paper with reinforced edges Do not use excessively curled paper Substance 110 (200 g/m2) must be long grain. Do not use short grain. Use transparencies with a white stripe. Freshly printed offset prints, use tray 3. Refer to the "Using various stocks" section for any stock not defined in this guide. Table 7-6. Satisfaction guide for paper tray 3 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives 8 x 10 inches to 17 x 11 inches (203 x 254 mm to 432 x 279 mm) Smaller or larger sizes cannot be used. 7-8 DocuTech 61xx Operator Guide