Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 96

Problem solving Table 6-3. Resolving a finisher problem Binder tape is too long or too short on the bottom edge of the output prints Adjust the binder tape length using the procedure entitled "Adjusting the binder tape registration" in the "Routine maintenance" chapter. If an adjustment is made to the binder tape length during a job, it will not take effect until the next job is printed. If it is necessary to adjust the binder tape length during a job, adjust it using the procedures in the on-line help. Loose binder tape along the spine of the completed bound book This is a symptom of excessive moisture in the tape. Replace the tape reel with a new reel using the procedure, "Replacing the binder tape reel," in the "Routine maintenance" chapter. Refer to the binder tape storage guidelines in this guide. Repeated tape feeding problems, such as binder tape not unwinding from the reel If the binder tape is sticking together, or if there are cosmetic defects in the bound book, replace the tape reel with a new reel using the procedure, "Replacing the binder tape reel," in the "Routine maintenance" chapter. Refer to the binder tape storage information in this guide. Refer to the binder cleaning information in this guide. Refer to information on calling the Customer Support Center in this guide. Stitcher fault codes displayed in the fault frame Select the [Finishing] button on the Printer Manager window. Deselect [Stitcher] on the Finishing window and refer to the procedure, "Calling for assistance," in this guide. Fault Code P12-218 Fault Code P12-219 Stitcher A problems. Perform the procedure, "Clearing a stitcher spool A fault," in this guide. Stitcher B problems. Refer to information on calling the Customer Support Center in this guide. Poor stitch quality or short stitches Reliable stitching can be expected with up to 65 sheets of substance 20 (75 g/m2) or 0.28 inch (7 mm) thick sets. Less reliable stitching can be expected with over 70 sheets of substance 20 (75 g/m2). Running intermixed stock heavier than substance 20 (75 g/m2) will reduce the capacity of the stitcher. To avoid short clinches, use the stitch override only when using a lightweight paper. Stitch override allows the system to run beyond the stitching limit. The system will shut down at 125 sheets. Reduce the stock weight to enable the stitching of more sheets per set. Refer to the satisfaction guides in the "Technical information" chapter. 6-8 DocuTech 61xx Operator Guide