Xerox 7300DN Network Users Guide - Page 46
UNIX/Linux Network, Overview, Quick install steps
View all Xerox 7300DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Phaser® 7300 Color Printer UNIX/Linux Network This section provides installation and troubleshooting steps for UNIX and Linux: Overview - see page 41. Quick install steps - see page 41. Additional resources - see page 42. Overview Your Phaser printer supports connection to a variety of UNIX platforms. Below is a list of the currently supported versions: Solaris IBM AIX Hewlett-Packard HP-UX DEC UNIX True UNIX 64 (Compaq) Linux (i386) Linux (PPC) SGI The procedures contained in this document enable you to connect your printer using any of the supported versions of UNIX or Linux listed above. Quick install steps 1. Print the Configuration Pages and retain them for reference. For information on printing Configuration Pages, refer to the Front Panel section of the Features Guide on the Interactive Documentation CD-ROM. 2. Check the Configuration Pages and verify that both TCP/IP protocol and the proper connector are enabled. 3. Go to the section IP Address and perform one of the procedures there, depending on the manner in which you want to set your printer's IP address. 4. Solaris: Refer to the CentreWare Services for Unix Systems User Guide (English only) included on the Printer Installer and Utilities CD-ROM for CentreWare installation and detailed printer setup instructions. Other UNIX OS: Load printer drivers and configure the printer for one of the Print Models. These drivers are available on the Printer Installer and Utilities CD-ROM or from the Xerox web site at www.xerox.com/officeprinting/support. Copyright © 2002 Xerox Corporation. All Rights Reserved. 41