Xerox DC240 DocuColor 240/250 Training and Information Guide in PDF format. - Page 99

DocuColor 240/250 Tray 5 (Bypass Tray) The Bypass Tray is a paper tray on the left hand side of your machine. It can be folded away when not in use. It is primarily intended for use as a small quantity, special materials feeder and accommodates stock of all types. The tray accommodates paper of weights between 17lb bond to 300gsm. Stock can be loaded either long or short edge feed (portrait or landscape). When lowered, the Bypass Tray can be extended to support longer length stock. NOTE: The Bypass Tray is only 13" wide, so some paper sizes must be SEF. The Bypass Tray accommodates all types of stock in a range of sizes between 4.0"x6.0" and 13"x19" and has a capacity of approximately 100 sheets of 20lb paper or a maximum stack height of 0.4". The Bypass Tray detects the position of the side guide to determine the size of the stock. When stock is loaded into the Bypass Tray, a pop-up window may appear asking you to change or confirm the type and size of the stock. The tray will not be ready for use until you change or confirm the size and type of stock. Alternatively, you can change the paper size and paper type by accessing the Paper Tray Attributes screen from the System Administration Menu. Your machine also alerts you if the Bypass Tray is selected for a print job where the stock selected does not match the stock currently loaded. It also warns you if the Bypass Tray runs out of stock during a job. DocuColor 240/250 Training and Information Guide 99