Yamaha 01V Owner's Manual - Page 31

Inputs & Outputs 23 D STEREO OUT These are balanced XLR-3-32-type connectors with a +4 dB nominal output level. They are wired pin 1-ground, pin 2-hot (+), and pin 3-cold (-). They output the main stereo mix. Female XLR plug 2 (hot) 3 (cold) 1 (ground) If you need to connect the balanced ST OUT to an unbalanced phone jack input, use a cable with the following wiring scheme (i.e., XLR pins 3 and 1 linked). Tip (hot) 1/4" phone plug Female XLR plug 2 (hot) 3 (cold) Sleeve (ground) 1 (ground) E DIGITAL STEREO OUT This phono jack outputs the main stereo mix as Coaxial format 24-bit digital audio, allowing digital transfer to a DAT, MiniDisc deck, or other digital recorder. F DIGITAL STEREO IN This phono jack accepts 24-bit Coaxial format digital audio. Signals input here can be fed directly to the Stereo bus for stereo cascade operation (i.e., two mixers working together), or to input channels 13 and 14. G MIDI IN, OUT, THRU These are standard MIDI IN, OUT, and THRU ports and are used to connect the 01V to other MIDI equipment for remote control and data backup. The MIDI IN port receives MIDI messages, while the MIDI OUT port transmits them. The MIDI THRU port transmits all MIDI messages received at the MIDI IN port. H TO HOST This 8-pin mini DIN port is used to connect the 01V to a personal computer for use with MIDI software. It eliminates the need for a computer MIDI interface, and together with the MIDI ports allows the 01V to be used as a MIDI interface for other MIDI equipment. I POWER switch This switch is used to turn on and off the 01V. It's recessed to prevent accidental operation. J OPTION I/O slot An Option I/O card can be installed here, providing access to the 01V's eight digital inputs and outputs. See "About Option I/O Cards" on page 216. 01V-Owner's Manual