Yamaha 500 YMC-700/500 Owners Manual - Page 15
Step 3: Source Device Setup
View all Yamaha 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Initial Setup 6 Check whether the TV turned on and off correctly. y • To cancel the TV Remote Code Test procedure, press BACK. • If the TV turns off during the test and does not turn back on after waiting over a minute, turn the TV on using the TV's remote control. Step 3: Source Device Setup 7 When the following message appears, select "Yes" or "No - Try next code". y Prepare the A Connection Planning Chart of the Quick Setup Guide in advance. In these instructions, the examples assume that the connections below are made. Select "Yes" to finish the TV Remote Code Test procedure or "No - Try next code" to check another remote control code. When you select "No - Try next code", the test mode of the other code starts immediately. Device 1 Cable box Time W CB-528 15 pt Note This unit does not contain all possible codes for commercially available TVs. If this unit does not turn the TV off/on with the codes provided for that brand, select "Learn Code" to recall the TV Remote Code Learning screen (☞ P. 42) and program the remote control code manually. 8 Select "Save" to finish the TV remote control code setting and proceed with the Initial Setup process. y When you want to set the TV remote control code again, select "Change Code". 9 pt 3 pt 3 pt 2 pt 1 pt 15 pt 14 En