Yamaha 500 YMC-700/500 Owners Manual - Page 42

ADVANCED OPERATION ■ IP Address Use this menu to change the network parameters (IP address, etc.) manually. DHCP (DHCP setting) Use this feature to select whether to allow this unit to obtain the network parameters (IP address, subnet mask, default gateway, primary DNS server and secondary DNS server) from the DHCP server of the connected network. Choice Descriptions On Select this setting to allow this unit to obtain the network parameters from the DHCP server of the connected network. Off Select this setting when you want to set the network parameters manually. IP Address (IP address) Use this parameter to specify the IP address assigned to this unit. This value must not be the same as the one used for other devices in the target network. Subnet Mask (Subnet mask) Use this parameter to specify the subnet mask value assigned to this unit. Default Gateway (Default gateway) Use this parameter to specify the IP address of the default gateway. DNS Server (P) (Primary DNS server), DNS Server (S) (Secondary DNS server) Use this parameter to specify the IP address of the primary and secondary DNS (Domain Name System) servers. y If you have only one DNS address, enter the DNS address in "DNS Server (P)". If you have two or more DNS addresses, enter one of them in "DNS Server (P)" and another in "DNS Server (S)". ■ Wireless LAN When you select this menu item, this unit automatically begins to search for wireless networks. After searching is completed, follow the steps below. 1 Select an access point, or select "Manual Setup" and enter the ESSID (the name of the wireless network named in the Wi-Fi settings). 2 Select the security type and input the security key for the network. When you select "None" as the security type, you are not required to input the security key. 3 Select "Yes" to confirm the setting. Setup menu ■ MAC Address Filter Use this feature to filter the access to this unit via LAN to control this unit by the MAC address of the accessing PC. Control range: 00 to FF for each field (Mac Address Filter: On, Off) Choice Functions Mac Address Filter Turns the MAC address filter function on or off. When "On" is selected, this unit accepts PCs whose MAC address is registered. MAC Address 1 - 10 The MAC addresses of network devices which are allowed to connect to this unit. ■ Information You can display the following network system information: • MAC Address assigned to this unit • IP Address • Subnet Mask • Default Gateway • DNS Server (P) • DNS Server (S) • Link Status of the network (No Link/10Base-T/ 100Base-TX) and method of communication (Full Duplex/Half Duplex) • WLAN Signal Level • vTuner ID Rhapsody® Information menu (YMC-700 only) Use this menu to check and change the account status of your Rhapsody® account. ■ Account Status Shows the information regarding the account status. If "NOT AVAILABLE" appears, check the network settings. ■ Sign In Enter your user name (up to 64 characters) and password (up to 64 characters) provided by the Rhapsody® service, then select "OK". Note If Sign In fails, an error message appears. In this case, perform the Sign In procedure again. ■ Rhapsody Free Trial A free 30-day trial of the Rhapsody® service is available. When you select this menu, the URL at which the terms of the trial service can be found appears. If you agree, select "Yes" to activate the trial account. ■ Remove Account Select this menu to remove your account. 41 En