Yamaha CDX-480 Owner's Manual - Page 8
Basic Operation - remote
View all Yamaha CDX-480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
This manual describes how to operate this unit by using the remote control transmitter. To operate this unit on the front panel, use the corresponding buttons on the front panel. BASIC OPERATION 1 POWER AUTO DISPLAY OFF 1 POWER 2, 3 OPEN/CLOSE DIMMER TIME PROG TAPE CLEAR PEAK SPACE S/F RANDOM REPEAT 1 2 3 +10 4 5 6 7 8 9 0 SKIP PAUSE PLAY SEARCH INDEX STOP - OUTPUT LEVEL + SYNCHRO 3 Close the disc tray. 4 OPEN/CLOSE 2 Label side upward 4 OPEN/CLOSE PLAY Disc tray Display information at disc play SINGLE 3 4 5 6 7 8 9 10 11 12 Shows the track number selected or being played. Shows the time displays. (Refer to "Selecting time displays" on page 10.) CDX-580 and CDX-480 only Shows the level of signals output into an amplifier or the headphone level adjusted by using the OUTPUT LEVEL buttons. Displays the numbers that correspond to the numbers of tracks (as high as number 20) on the disc. After each track is played, its corresponding number disappears so the number of remaining tracks (and their numbers) can be seen at a glance. To turn off the power 8 Press the POWER button again. Play will begin from the first track of the disc. Notes • After closing the disc tray by pressing the OPEN/CLOSE button, the display shows the total number of tracks and the total recorded time of the disc for a few seconds. TOTAL 1 2 3 4 5 6 7 8 9 10 11 12 • Additionally, you can close the disc tray by pressing the PLAY (PLAY/PAUSE) button, a numeric button or the RANDOM button, or by pressing the front edge of the disc tray gently. If the tray is closed in these ways, play will begin automatically, however, the display will not show the total number of tracks and the total recorded time of the disc.