Yamaha CL3 Cl Editor Owner's Manual - Page 37
If a MIX channel is selected, CHANNEL SELECT Channel selection, TO MATRIX
View all Yamaha CL3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
If a MIX channel is selected ❏ CHANNEL SELECT (Channel selection) 1 2 1 SELECT (Channel selection) Except for the fact that your editing applies to a MIX channel, this is the same as the channel selection for an input channel (➥ p.26.) 2 LIBRARY Accesses the Output Channel Library. Click this button to open the OUTPUT CH page of the Library window. 3 PATCH (Output patch) Selects the output source assigned to the Mix channel (for the selectable 3 output sources, ➥ p.17.) ❏ TO MATRIX 1 2 3 4 1 MATRIX send level This adjusts the send level of the signal sent from the MIX channel to the MATRIX buses. 2 PRE (PRE on/off) Select either PRE or POST as the position from which the signal is sent from the MIX channel to the MATRIX bus. PRE EQ or PRE FADER is selected if this is on, or POST FADER is selected if this is off. The PRE EQ/PRE FADER setting can be made in the Mixer Setup dialogbox. NOTE Right-click the PRE button to display a context-sensitive menu that will enable you to specify ALL PRE, ALL POST, or other options. HINT • If you are using MATRIX buses in stereo, the knob for the odd-numbered bus will be PAN or BALANCE. • The stereo/mono status can be specified in the Mixer Setup dialogbox. Knob of odd-numbered side 3 ON (MATRIX send on/off) This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus. 4 Channel name This section indicates the MATRIX channel name. 37 CL Editor Owner's Manual